why generally transformer are in star to delta or delta to
star used?
- 8 Answers
- 18727 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rashid
As per question, we use delta /star or star /delta as per
our system requirment bcoz we need star connection to get a
nuetral and phase for our protections in case of delta we
are not able to do this, and otherwise the delta connection
is better for system stability also we also need star at
end users where we need single phase supply,
| Is This Answer Correct ? | 6 Yes | 20 No |
Post New Answer View All Answers
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
The height to which the liquid in a tank to be maintained for a certain constant velocity?
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
Hoe do calculate the Cable size for Amps rating ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
what are symmetrical and non symmetrical components in electrical installation.
How to minimize the eddy current losses?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
what mean by analog ,digital,numerical meters and relays? say the example?
What is a feedback in control system?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
what is resver in electrical enginnering with answer
Can we Co-ordinate relay in Load Break switch?
