Interested to Buy Any Domain ? << Click Here >> for more details...
What is the acceptable percentage of slump in Mix concrete?
- 9 Answers
- 27339 Views
- I also Faced
- E-Mail Answers
Answer Posted / sakthi
FROM THE SLUMP TESTING EQUIPMENT WE CAN FIND OUT THE RESULT
OF SLUMP.
BUT,
MORE THAN 125MM IS HIGH FLOWING CONCRETE,SO NOT ADVISABLE
FOR CONCRETING.
LESS THAN 25MM IS VERY HARDEN CONCRETE HAS LESS PLASTICITY.
FROM 25MM TO 125MM WE CAN USE AS PER TYPE OF CONCRETING.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
what is the use in canals of longitudinal drains and cross drains in lining areas?
What is kn measurement?
how can calculate the compressive strength of concrete cylinder by water cement ratio ?
How to calculate dry of volume of concrete constant?How it comes 1.54 or 1.57
Pls provide me with the calculation or codes related to de- shuttering of flat slabs
in plate load test what is the thickness of plate 20mm 5mm 50mm none
how to find quantity of concrete in PCC M15
suppose that 156000 sq.ft rcc work builtup are.how many % of brick work to rcc work.
Define What is diversion tunnel in a dam?
what is the minimum compressive strength of clay brick
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?
What in bending moment, if a moment is free end of cantilever beam?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
How to arrive the co- efficient of all civil activities? For ex:- painting-enamel in wooden doors. co efficient is 1.8. How this is calculated
