Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using R,Y,B colours for 3 Phase ?
- 4 Answers
- 10251 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / sunil parmar
THE WAVELENGTH OF THESE THREE COLOURS IS HIGHER AND ALSO
THE SCATERRING CAPACITY IS LESS THAN THE OTHER COLOURS SO
COULD BE EASILY IDENTIFIED.
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
why single phase to grd test in HV cable?why not 2 phase at a time?
What is error of a measurement?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
why is using sensor?what is differece between photoelectric and proxmitty?
why power factor is important?
why a tester wont shock while testing the power in house
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
what is Anti-pumping?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
what is the difference between earth leakage and earth fault?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
Testing procedure of DG alternator stability test
