can SMPS work in DC supply ?

Answer Posted / sunil parmar,nirma uni.

yes,SMPS can work in a DC supply ----
simple conv. function with AC supply in SMPS

AC--step down to AC---rectified to DC---further step down
to required DC---filtered---o/p

now conversion procedure with DC supply in SMPS

DC---with the help of chopper converted to required DC---
filtered---o/p

plz vote for my answer..
for reply or disagreement mail me at
parmar20072008@yahoo.com

Is This Answer Correct ?    14 Yes 2 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

how to find the resistance and gap volatage of the diode??

1565


a starter used for squirrel cage induction motor?

1218


What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.

2227


sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in

1559


How to run a three phase motor into single phase........

1578






I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is likerahulworld@gmail.com

1371


Why we use duplex coil and hook switch in telephone system?

4587


can anybody sent me power grid questions. what subject should i prefer for preparation?

1651


whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11

1447


How to calculate impedance volt in Transformer?

1560


if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)

1342


What is stepper motor?

732


the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

1645


we specify current in case of feeder but in case of distributor voltage, why?

1385


Form S and "c" license application both are same? @ tneb portal

1267