What is the most common layer 2 device?
A. Hub
B. Bridge
C. Switch
D. Router
- 20 Answers
- 23011 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / sundarrajan.s
C.Switch
| Is This Answer Correct ? | 21 Yes | 2 No |
Post New Answer View All Answers
How many maximum paths you can give on latest ios in rip?
Why is distributed processing useful?
What is a Frame Relay?
what are the different symmetric algorithms?
Which command we give if router ios stucked?
Explain the difference between rip and ripv2?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
Can you explain VPN tunneled packet in detail?
Why is vlan used?
After how long ospf exchange its topology table?
What s the formula for metric of ospf?
Which LAN switching method is used in CISCO Catalyst 5000?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
If there is only 2 host in bus topology is that possible collision accord?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
