Interested to Buy Any Domain ? << Click Here >> for more details...
If i switch on a transformer but with no load connected to
the secondary path.Is the transformer will burn?
- 5 Answers
- 8062 Views
- I also Faced
- E-Mail Answers
Answer Posted / denzel101
The POWER TRANSFORMERS cannot burn when supplied and
unloaded as it will draw magnetising current only.To add a
little info,I think the phenomena is applicable to CURRENT
TRANSFORMERS due to saturation of the core not on power
transformers.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What is referred to the electron in the outer orbit?
what is mind in cable
What do you mean by the zone of protection?
how you taken aotitude test
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
What is the problem of internal failure in ship engine telegraph system norcontrol?
what is the differences between microprocessor and general purpose computer
What is servo motor and what are different types of servo motor
what is the meaning of WYE and DELTA in Electric meter?
what is meant by re-rolling motor? how it differs from standard motor?
Is vtg is controlled by the resistor? if else how much?
Air refrigeration cycle works on the
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
block diagram of 2 ups system connected in parallel mode?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
