Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manikandan
actually differential relay function in transformer . this
relay monitoring the both side current(primary and seconday)
if current diffrent occure in transformer i t will be trip
the incoming breaker.
| Is This Answer Correct ? | 42 Yes | 1 No |
Post New Answer View All Answers
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
difference between high and low impedance BUS BAR relay??
BSNL TTA EXAM QUESTION
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
what is control supply rating of a machine
how to find the torque of the single phase synchronous motor by doing an experiment
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
can u give me a brief idea about power line carrier communication ??
List some examples of renewable energy?
what clearance required for 4.5 mva dry type transformer?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
which type of stability limit is higher,steady state or transient? why?
