Interested to Buy Any Domain ? << Click Here >> for more details...
WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER
FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE
EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY
AS YOU SUGGEST ?
- 32 Answers
- 59645 Views
- L&T, MCL, I also Faced
- E-Mail Answers
Answer Posted / alok.bahukhandi999
being a colony of the britishers for about 200yrs ,all the
standards in india were set up by the britishers.therefore
the frequency in india is tuned to 50hz since the same is
used by the britishers.after the post independence period
if india would have changed its frequency then it would
cost a lot to india and will be a huge hurdel in the
development of a country like india.as far the range is
concerened it lies in the band of 45 to 75hz(which is most
efficient) and we use the average or the figure i.e 50 or
60hz.at present if we change the frequency then the
efficiency of all the machines and the entire power system
will be drop by about 20% which in return would drop the
growth rate of india .
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
which protection used in power plant?
How to check the LM324 Ic
How much load can take a 16 mm aluminum cable 3 phase
why is using sensor?what is differece between photoelectric and proxmitty?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
state basic meaning of 'INDUSTIAL AUTOMATION'?
what is v/f control in VFD?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
What are the advantages of nichols chart?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
