Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when a electric bulb is connected between
two phases.it will glow or not
- 18 Answers
- 44748 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.n.kumar
no,the bulb is not conected complet path this is connected
2-phases.
| Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
how to find the resistance and gap volatage of the diode??
explain single phase series motor
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
why high speed tripping relay will be used in tripping circuit why not normal relay
What are the advantages and disadvantages of open loop control system?
What is an Air COmpressor
What are the uses of lead compensator?
why do we carry out winding resistance test?
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
Can we use shunt trip coil instead of trip coil with protection relay for protection?
