Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / m.rajesh
Rankine Cyle
few power plant using reheat & Regenrative cycle
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is the use of pneumatic system?
How does hydraulic clutches work?
What are the effects of carbon on the properties of steel?
low of heat transfer
Why do you need a biological shield in nuclear plants?
How to find DG efficiency and unit per litre
how gravity filling machine is designed
How many types of oil spilling available?
hello sir iam atul joshi from mechanical branch. i want to know about the syllabus of technical ques of jindal steel
Explain what meant by Transmissability in Vibration ?
Which instrument measures speed in a car?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What are the symptoms of broke piston ring?
different between general arc welding & aluminium welding?
If you want to provide water or any chemical @ 50 meter height how much head will you prefer for any selected pump...consider it is M.S pipings...how much friction loss will be there...show with calculation.
