Answer Posted / prakash gokhale
CL5P 10
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
how technical is calculated in 11kv line and lt line
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
what is the requirement regarding earthing of Single conductor with AWA
What is the function of electron gun assembly used in crt?
what is buffer resistance starter.?.What is the working principle and where it is used..?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Why neutral is not used in three phases dol starter
what is diff btw electric,magnetic & eletromagnetic field
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
Why do we use copper cable for HT Supply and why not Aluminium?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
