what is the difference between client mode and server mode of
vtp and what is the diffrence betwwen tarnsparent mode and
server mode
- 7 Answers
- 19809 Views
- Bhel, IBM, I also Faced
- E-Mail Answers
Answer Posted / brijesh
We run vtp over trunk links also known as tagged links. VTP
(Vlan Trunking Protocol but this is not a purely trunking
protocol it is Vlan Replication Protocol).
It has three default modes:
1. Server:
In this mode we can create, delete, modify any vlan/vlan
data. We can delete vlan.dat etc.
2. Client:
In this mode we can only use the services of vlans but we
can not create/modify/delete any vlan.
3. Transparent:
In this mode the switch can forward the vlan from server
to client etc. This feature is available only in VTP V2.
In case of V1, we have to create server configuration again
when any Transparent Switch comes between the network.
NOTE:
In the case of Server we can create default vlan 1-1005,
also known as Standard Vlans.
In the case of Transparent we can create vlan 1-4096 (valid
range 1-4094) also known as Extended Vlans.
Brijesh
cisco.brijesh@gmail.com
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How is rip different from igrp?
What are 10base2, 10base5 and 10baset ethernet lans?
What is the difference between half duplex and full duplex?
Which protocol can do load balancing on unequal cost also?
What is the difference between csma/ca?
If bandwidth will increase what will happen?
Why subnetting is used?
What is the difference between the switch, hub, and router?
What will be the prefix length of 224 in vlsm?
Brielfly explain the conversion steps in data encapsulation
Explain on which interface we always apply access-list?
Tell me which cable called roll-over?
What is the different between console port and auxiliary port?
What is fcs?
What is the passive topology in ccna?
