Interested to Buy Any Domain ? << Click Here >> for more details...
In oil transformer which oil is used & what should be the
insulation resistance & heating capacity.
- 2 Answers
- 5079 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.naidu
Naphthenic mineral oil ( higher flash points ) and minimum
safe insulation resistance in 33KV TR-500 ohm
11KV TR-300 omh
insulation at temperaturs more than 120 to 140 c the gas
bubble are formed as a result of insulation deterioration
these is reasion of leading breake down.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What is the significance of integral controller and derivative controller in a pid controller?
What the difference between ac and dc inductor an capacitor
how much GROUND & NEUTRAL VOLT maintain in data center.
how to test power transformer.YNd11
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
3ph motor running with unequal kw and different pf what are the reasons
What is miller crystal oscillator? Explain its operation?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
explain which quantities change in the starting and the and the running condition in induction motor
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
What is the purpose of stand by earth fault protection for transformer ?
What is ramp signal?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is the difference between interconnection and intraconnections in the circuit diagrams
