Answer Posted / s.samjeba singh
Fuses are used to protect the equipment connected in the
circuit to protect from over current. phase is the entry
path for supply and neutral is the return path of suppy if
we use the fuse in return path(neutral) the equipment
connected in the circuit will get damage then only the
supply will reach the fuse
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
What is meant by Load Encroachment in OHL Feeder Protection?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
what is load vs Torque curve & why it is used?
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
What is an automatic controller?
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
how many stairs have you climbed while you were coming
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
What is line resistance of cable & how it can be measured ?
Write down the design procedure of commutaj.
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
What is electrical cable termination
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
