Interested to Buy Any Domain ? << Click Here >> for more details...
I have a shop heater with a 1/3 hp capacitor start,
induction motor driving the fan. Intermittently, the fan
motor speeds up significantly for several seconds (15-60
sec) then slows to normal operating speed. The manufacturer
suggested changing the capacitor which made no sense, but I
did it to no avail.
Could this possibly be caused by the centrifugal switch
intermittently reconnecting the start winding?
- 1 Answers
- 3769 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
Just a possibility.How big is the heater May be when the
heater is "on" the voltage drops so the fan is actually slow
but when the heater cuts out due to thermostat the voltage is
near normal and the motor is functioning at normal speed.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir plz send some previous year questions of jspl.
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
You are of electrical field and you are going for software? Why
If not into production, how far did you follow the design and why did not you see it into production?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
if we have 320KVA Genset kindly advice how much load we can put it.
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
Lt motor sfu flashing reasons?
HOW TO CALCULATE HV CABLE SIZING?
What is the basic rule for block diagram reduction technique?
wat is the first thing dat is needed, 2 lay a cable in some area??
Why is tan-delta test and capacitor measurement done on alternator?
