Interested to Buy Any Domain ? << Click Here >> for more details...
if the t/c o/p is 4-20mv then how plc recognize it
because we are dealing with the 4-20ma in the
plc ????????????????
- 7 Answers
- 11048 Views
- I also Faced
- E-Mail Answers
Answer Posted / sattar
Voltage to current converter using op-amp
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
line up procedure for dp type flow transmitter?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is maxdna ?. explain about the software details.
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
which type of zones used for boiler? & why ?
draw shematic diagram of c/v positioner(smart type)?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
what is your eligibility criteria for freashers?
How the warning lamp of a charging-system is activated ?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
How to erection of DCS Panel at site step by step
