What is a roll of a adopter pannel in buscoupler pannel????
- 2 Answers
- 3770 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhiren
I really dont know the answer,please answer it
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how many Classification of fire extinguisher
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
Difference between RCCB, RCBO and ELMCB.
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
Define sensitivity?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Define end float in a motor?
how to select energy meter? have any calculation?
