Interested to Buy Any Domain ? << Click Here >> for more details...
1.What is the difference between safety valve and relief
valve?
- 9 Answers
- 42599 Views
- Covanta Energy, I also Faced
- E-Mail Answers
Answer Posted / sunil
relief valve protects a system against excessive pressure
.....normally it set to desired pressure value by its spring
setting ........as the pressure exceeds its limit fluid is
diverted to tank through relief valve.......heat loses are
encountered due to throttling involved
safety valve is general category in which different valves
are included such pressure safety valve and temp safety valve
safety valves could be based on the setting of temp
| Is This Answer Correct ? | 5 Yes | 38 No |
Post New Answer View All Answers
I am completed diploma in mechanical in 2002, i have 5year experience in materials (purchase) dept,i want to do SAP cource in MM module, i want to know can i complete SAP after diploma cource only, is it usefull to me for further Job opening.
Heavy fuel oil sulfur content and counter measures?
Crankcase oil mist detector
What is injection tag?
What are the types of sensors?
Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)
if the blade height is increased,then how it increases the specific speed of centrifugal pump?
Why is the suction pipe of vapor compression and refrigeration system insulated?
Which types of questions ask in pool campus pune in technical and aptitude test
What is acceleration
Explain how the cylinder lubrication on main engine is done?
I need BHEL apptitude questions
Dear Sir, i want to know formula for steel BAR/SQUARE/HEX/FLAT>LENGTH. SUPPOSE I PURCHASE 10 KG OF ROUND BAR OF DIA. 20MM SO WHAT LENGHT I GET. SAME FORMULA FOR HEX/SQUARE.?
From where i can get cds about mechanical related subjests
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
