in a transmission line the aluminium cor is sarrounded and
in between there is a another type of matrial what is that?
Answer Posted / rishi tiwaeri
if you are taling about overhead line then al uminium is
not in center because of skin effect
if you are takling about expanded wire then there is
fiborus or paper type insulation is used
if in udergrond there is dffreent type pvc & valcunized
rubber is used depend open the voltage stress & working
temprature
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the ratio of Booster transformer?
how can we design robots
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
why the pf of semiconductor device is improved the electrical devices
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
which types of relay used in acb and vcb?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
Why you want to join non technical field when you are an engineer?
What Is Sampling?
should %impedance be high or low in a power transformer? if so why?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
1.What will be stored in online ups EPROM IC?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?