Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chandu
power copy is a set of features that are grouped under to
use in diff context&having the capability to adapt changes
when pasted
| Is This Answer Correct ? | 57 Yes | 7 No |
Post New Answer View All Answers
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What causes hardness in steel ? How heat treatment alters properties of steel ?
What do you understand by heat treatment?
What is the difference between nuclear fission and fission chain reaction?
Explain the types of sensors.
When did you decide to become and mechanical engineer and why?
What is the difference between upstream and downstream in a refinery?
why the path of a satellite is always elliptical with earth not at the centre of the ellipse?
difference between microcontroller and microprocessor
Hiii...I am from instrumentation dept in last plant and now in new plant management transferrd me to turbine dcs operation...how and which way I can prepare for dcs operation...time is just 1 month...???
distance between the power generation and the distribution to the application is fixed or vary
8000 Liter Water in 80 degree Celsius will generated how many STEAM ?
How are voltmeter and am meter connected in the circuit?
What is IS standard in case of mode of measurement for ducting
