why making capacity is more than breaking capacity?
Answer Posted / avdhesh
I think Pratik has given the exect answer. I wish to add
one more thing during closing of a circuit breaker. When we
close the breaker, there is rebounses of the contacts( 5-6
rebounces are normal in VCB). During transient state (Plus
fault) there is a chance of melting and welding of contacts
hence breaker making capacity is always required high.
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
what are the difference between AC lamp and DC lamp
What is Harmonics how it is produced and what is the method to control the same
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
what is the usage of microcontroller in the panel board?
how to find the capacitance value of the motor while running??
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
What is the unit of attenuation?
what is mean by D.O. in distribution line poles?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
How many types of faults are there in 3 phase power system?
plz send me the procedure and syllabus for mseb exam
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.