Interested to Buy Any Domain ? << Click Here >> for more details...
what is the main purpose of line PT and bus PT?
- 11 Answers
- 82634 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / vels
the sensitivity of voltage drop of line PT during the line
fault condition is high than a bus PT
vels
| Is This Answer Correct ? | 10 Yes | 17 No |
Post New Answer View All Answers
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
If increased the frequency up to 1000 then what changes shows in voltage?
how to flameproof electrical motor on the shaft?
what is subtransient , transient and steady stateac components
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
what is the relationship between current&voltage in practical purpose ?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
can i connect REF and Differencial relay in 1 CT core for transformer protection?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
