railway exam in asst loco pilot
old test paper
Answer Posted / shailen chakraborty
yes,
Is This Answer Correct ? | 39 Yes | 6 No |
Post New Answer View All Answers
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
How to synchronization will be done between two DGs ?
help me with the question that might be ask on the interview for technical position
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
Which Class insulation is prefered for the sandwich Busducts ? Why?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
at what base you will tell the direction of rotation of dc motors and generators?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to get electrical supervisour certificate in gujarat
Name two low frequency oscillators?
Rules and standards of electrical control wiring ?