Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jagan
This test is doing for bushings of high rating CVT
transformers .this is very essential test it should be in
determined value max in nanofarad.whwn u conduct this one
to three times clean the bushing.this have many provision
when u using special kit.max GST-g mode is using by
applying 10Kv.
| Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
what is the relation between size of the anteena and wavelenghth of radiated wave
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
How can find thermal state value in relay for calculate thermal overload.
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
why power factor is important?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
what is the relative size of single and three phase?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what are the different kind of cables used for transmissions?
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
