Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference about HART, and 4-20mA signal?
- 8 Answers
- 43472 Views
- I also Faced
- E-Mail Answers
Answer Posted / haridass
HART Communicator - is a device used to communicate with
the HART / SMART family transmitters, used in the process
control.
* To monitor the PV, Current mA value, Sensor Temperature,
* It is used to re-range the transmitter,
* damping adjustment,
* trimming the sensor of zero/lower/upper ranges.
* create the tags/messages of the transmitter.
* Review the complete details of the transmitter.
* Loop testing the control loop (Indicator/Controller), etc.
Whereas the 4-20 mA source is used for the following:
* To simulate the 4-20 mA signal (For calibration of
control valves, loop testing of the closed/open loop).
* Using the high accuracy 250 ohms resistor, we can get 1-
5vdc as the output which is useful for the DCS input.
| Is This Answer Correct ? | 11 Yes | 12 No |
Post New Answer View All Answers
what is a half wave, full wave, and bridge rectifer.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Introduce yourself which is not present in your biodata?
What is Predictive Maintenance
Name different parts of a pressure gauge.
What you mean by multi stage control vavles?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
any body please send me the old question papers of ongc test.
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
why is not useing in boiler skin thermocople
what is the working principal of pribe
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
pls give me presant awerness quistion and answer in my emailid.
Where is wet leg is used?
