Answer Posted / tithi dey
The Function of lead sheath of the cable is to protect the
cable from the mechanical damage.
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
What is the effect of pd controller on system performance?
what is p.s impedance measurement test in earthing transformer?
How to reduce -234126219.6403 MVAr generation and by what?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
what are factors to be consider in electrical installation like load factor,diversity factor .....
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
what is gridrotor resistance starter
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
