Interested to Buy Any Domain ? << Click Here >> for more details...
why neutral of 6.6 kv star connected sq. cage induction
motor does not get earthed, though for earth fault
protection it is must.
- 7 Answers
- 13534 Views
- I also Faced
- E-Mail Answers
Answer Posted / velusamy
THE PURPOSE OF PROVIDING STAR CONNECTION IS 1.DEPENDING ON
THE DESIGN REQUIREMENT OF EQUIPMENT 2.TO PROVIDE PROTECTION
AGAINST DIFFERENTIAL
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
What is electrical diversity factor in electrical installations?
what do w do when the output of generator is fluctuating?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
Define the term factor of inertia.
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
at what base you will tell the direction of rotation of dc motors and generators?
