Interested to Buy Any Domain ? << Click Here >> for more details...
How to increse bearing capacity in soils (Stabilisation of
soils)
- 12 Answers
- 22165 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramir v. agustin
If condition of soil is very poor and higher soil bearing
capacity is needed especially in areas where big structure
or building is to be constructed, soil improvement should
be done.This should be accomplished by excavatiing the area
and and backfilling at least 150mm minimum of road base or
sub grade then subject it to compaction.Also you must know
the MMD(maximum dry density) and OMC (optimum moisture
content of the the soil for backfilling to be used to know
how much degree of compaction you will apply.The no. of
layers and thicknes of soil depends on Load Bearing
requirements.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how we check the thickness and line of ceiling plaster.
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
What do you understand by “preset” during the installation process of bridge bearings?
What should be the maximum allowable time for placing ready mix concrete? The specification requires concrete placement within 90 minutes of batching at the plant. What is the significance of this 90 minutes & should this be used as a rejection criterion? What effects does the concrete has after that time period?
which are the Indian auther books for STONE COLUMN/GRANULAR PILES?
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
What is the distance between railway tracks?
how i can calculate the actual nos & size of steel to make 1000sqft. x 3"thick slab
for 32 dia (EQR HYSD steel) bar how much deduction for 45 and 90 degree band
How to calculate the cement and fine aggregate requirement for solid block masonry works in terms of Sqm. 1. 400x200x200mm 2. 400x200x100mm 3. 600x200x100mm 4. 600x200x200mm I need the answer for 1 Sqm of solid block works.
Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?
How to find out slope footing concrete
What is an ortho mode?
Can compresive strength test for concrete at 1 day age possible to carry out? If yes, which IS code describes the procedure for such testing?
how to identify the failure of building by expansive soils
