Answer Posted / dinesh sharma bhardwaj
Armed use in the cable for maintain its tension and remove
the saging. Secondly armed protect the cable from
mechanical damage.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
Where servomechanism is used?
Why is negative feedback invariably preferred in closed loop system?
Why ground terminal is used in pot meter 10k ohms
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
what is the reqirred voltage in HT motor to get full RPM on no load test?
which of the following elements is not present in stainless steel
my diploma certificate in my higher education college
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
WHAT IS counter flux IN CT?
What is ramp signal?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is transient response?
what is class of SPD and dittels of all class ?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
