Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference about HART, and 4-20mA signal?
- 8 Answers
- 43187 Views
- I also Faced
- E-Mail Answers
Answer Posted / prince
normally in industries we use 4-20mA signal to transfer the
signal from a transmitter to the control system.nowadays
the trasmitters are smart type. so a HART is a device used
to communicate with this smart transmitters to get the data
online or offline. HART is a digital device, so this
digital signal will superimpose on the analog transmiiter
signal without disturbing it.
| Is This Answer Correct ? | 19 Yes | 14 No |
Post New Answer View All Answers
in mass flow meter what is drive friquancy ?
How it the difference between force balance system and dispalacement balance system?
how to check earthing,what is minum ohms for proper earthing
please send the sample qustion paper for iocl written test ..
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
How does your previous experience relate to the job you are applying for ?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
What is the difference between ff transmitter and non ff transmitter
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
Explain an adaptive / self-tuning controller’s major draw card.
where proximity sensor installed on tank in loading arm application
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
what diffrence b/w plc s7200,300,400
Explain the key components of control loop?
What is three element in drum level?
