there is three mode of vtp let there are three switch s1 in
server mode s2 in transparent mede and s3 in clint mode
then will that tranparnt mode going to effect the network if
yes then how and if no then what it will do
- 2 Answers
- 3556 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / anil
yes because in transparent mode information is not synchorized
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
hi shain can u send me some detail about bgp so that i can enhance my knowledge over bgp and can you also teach me about the process of suppernating. now what i am thinking that this could be last visit on that site overhere.so please mail that short of thing on my gmail id i am requesting to all of the visitor that please send theire doubt or question to my new gmail id which is jitendera.ccnainterview@gmail.com.i will try to solve it if i am capable to do it Wishing all of you for great future Jitendera kaumar sinha
Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...
On which interface we always apply access-list?
Mention what BOOTP is?
What is cisco?
which defined peer ip address an local subnet belong to crete? (Choose two)
Name the vtp modes?
Mention what is dhcp?
What is the mesh network?
What are the things that can be accessed in a CISCO router’s identifying information?
What is the difference between rip and igrp?
What is size of ipv4 mac address?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
What’s the easiest way to remotely configure a router?
Explain the difference between bus topology and hub?
