Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between electric and electronic circuits?
- 11 Answers
- 28244 Views
- I also Faced
- E-Mail Answers
Answer Posted / vilas
Electrical circuit generally deals with more than 24 volts
consist mainly power circuit and control of ,relays,
contactor,motors ,load component.Whereas the electronic
circuit deals with voltage lower than 24 volts, consists
diodes, resistors, transistors,plc,and electronic controls
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is the disadvantage in proportional controller?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
condition Autotrip facia come on control panel of electrical transmission line?
What is mean by hot and cold loop testing?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
1.What will be stored in online ups EPROM IC?
How to prepare electrical preventive maintenance plan & shedule of machine tools in manufacturing unit.
What is the comparison of PILC and XLPE cable
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
State thevenin’s theorem?
how wecalculate breaking capcity of acb mcb mccb .explain with example
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
what is the difference between unarmoured & Flexible cable? How to identified?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
