what is the purpose of vector group in a transformer ? if 2
tranaformers r connected in parallel the vector group is
same or not?
for parallel operation 2 transformers of different
manufacturers maintain same vector group or not?
- 3 Answers
- 12863 Views
- Orchid, I also Faced
- E-Mail Answers
Answer Posted / imran
There are normally four vector groups weriten on generator
name plate, DY0, DY11, DY1 and DY6. DY means delta on H.V
and Y on L.V side. the number with this means the phase
displacement between input and output. 0 means no phase
displacement, 1 means -30 degree and 11 means 30degree and
6 means 180 degree it is according to the clock
revolution.vector group must b same for parallet operation.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
Please elaborate th´evenin’s theorem?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
How wire size can define in electrical wiring? What is the ratio?
can we use engine degreaser for electrical motors?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
at which voltage level arcing ground is occurs ??????????
which type of stability limit is higher,steady state or transient? why?
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
I want to know how to calculate the size of electricity cable in building?
what is thresold of perception
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
How to Calculate the Fault Level of Electrical Installation
