why we are caling 440 volt 3 phase supply instead of 660
volt 3 phase supply? because each phase as a voltage of 220
volt. if anybody know the answer for my question please
send it to my mail id. thank you.
- 3 Answers
- 22205 Views
- College School Exams Tests, Jindal Steel and Power, JIOL, NEC, I also Faced
- E-Mail Answers
Answer Posted / vishnu kumar
It can be justified from the phasor diagram....the effective
value can be determine as sqroot(3)*v.
| Is This Answer Correct ? | 19 Yes | 10 No |
Post New Answer View All Answers
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What does the term power factor shows?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
Why Transformer Neutral having one earth pit ( more earth electrode resistance) whereas body have many earth pit ( less earth electrode resistance)?
What is a parabolic signal?
how many load we can take for lighting
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
how to test power transformer.YNd11
What is the formuala to calculate the rating of motor protection circuit breaker
kindly send me 11KV MV motor differential protection procedure by primary injection method.
What is the difference between Delta & Wye windings?
What is meant by celling voltage & current in excitor ?
