Interested to Buy Any Domain ? << Click Here >> for more details...
what is power factor? how can we correction the power factor
if this is high or low? If anyone know please please send
the answer on my email id ( kumarkirshan@in.com )
- 5 Answers
- 8416 Views
- I also Faced
- E-Mail Answers
Answer Posted / syed qamar abbas
Power factor is the cosine of angle between voltage and
current.If the voltage is leading and current is lagging
that means power is of lagging nature, if current is
leading voltage then its of leading nature and if both
voltage and current are in same pahse then its unity.By
injecting reactive power power can be corrected, if power
factor is lagging then it can be corrected by injecting
capacitive power (KVAR)by means of capacitor banks and if
its leading then by means of inductors.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is the exact formula for one weber of magnetic flux?
How to measure the Harmonic Distortion of UPS ie THD?
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
write a program that prints prime numbers from 1-20 in digonal form
Operation carried out in thermal power stations?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
why we use copper earthing for neutral while for body GI.
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
What are the advantages & disadvantages of a group electrive drive?
how to calculate compresor capacity?
how to select rating of HT Panel
How to test the Secure Elite 440 Multi function meter working condition.
what is the differebt between ac and dc fuse?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
