Interested to Buy Any Domain ? << Click Here >> for more details...
can we transmit power with out cable if it is possible how
it is possible.
- 2 Answers
- 4751 Views
- I also Faced
- E-Mail Answers
Answer Posted / glen saldanha
one example is rfid(radio frequency indentification)
if a radio wave of a frequency same as that of the crystal
oscillator matches then voltage is generated this is used
in rfid
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
Do u know any one? how to find out in motor rated amps? formula?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what causes contact chatter when there is no demand on the air conditioning unit?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
Electronic circuit
What is meant by coupling capacitor?
why servomotor motor? where i apply for best output?
what is saturation kit?which use above 15 kw motors panel side.
Why the output of OP-AMP is always less than Vcc?
what is integrated ac contact circuit
