Interested to Buy Any Domain ? << Click Here >> for more details...
Brushed alternator is also called dc generator ? its true
or false ?explain it ?
- 5 Answers
- 7520 Views
- I also Faced
- E-Mail Answers
Answer Posted / thuranga
I exactly does not know the right answer for it...but what I
think is ,in the alternator the AC voltage collected at
sliprings where it turns out to be ac becoz there will be
not breaks as on commutator(for DC gen/mot)
so as far as I know if the alternator consists the mica gaps
on the shaft or commutator then it acts DC gen....
but without those gaps even if we put the brushes also the
current collected at brushes will be ac only.but the only
problem is the maximum power will be wasted at the brushes.
(this is my view,tell me if it is wrong).thanking you
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the different types of hydro schemes?
How to calculate the fuse rating depend upon the DC circuit?
Name two types of electrical analogous for mechanical system.
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
Which is the oldest hydropower plant in india?
Write the current equation in series RLC circuits.
How to calculate the heat load for a electrical room
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Where voltage are high and current to be interrupted is low the breaker preferred is:
explain supply side and demand side energy management with advantages & disadvantages
What will be the effect if I use inverter as UPS mood?
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
