Interested to Buy Any Domain ? << Click Here >> for more details...
we can stepdown the voltage from 230/12v ,and we use the
voltage for various electronics components why can't we
step up the voltage from 12/230v if we can shall we use the
voltage for domestic single phase supply
- 5 Answers
- 9104 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / santosh kawade
We can step up AC (alternating current) 12V to 230V by
using 12/230V transformer.
To use the voltage for domestic single phase supply we have
to match domestic appliance rating and 12/230V transformer
and its source rating.
Santosh Kawade
9224 69 3116
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
Which is the oldest hydropower plant in india?
how much leakage current is allowed in MC61A L&T make relay?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
hi friends if you have any 400KV Substation Erection and installations Drgs please send to me.My email id:kandi.suresh441@gmail.com
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
As i want some model question paper in basic computer science and history please send me immediately sir
how to build a network which step down 415v to 1v rms
what is meant by impedance & transient protection?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
Why squirrel cage motor can only use with low starting loads ?
what is booster? and how it is connected in a circuit?
If not into production, how far did you follow the design and why did not you see it into production?
