Interested to Buy Any Domain ? << Click Here >> for more details...
what is rotor earth fault protection scheme in hydro
generator & what is dc field flashing ?
- 2 Answers
- 9207 Views
- NHPC, I also Faced
- E-Mail Answers
Answer Posted / santosh kawade
Rotar earth fault protection for generator (hydro or
thermal same scheme):
Rotar earth fault protection contains two stages 1st stage
earth fault protection and 2nd stage earth fault
protection.
As per scheme in normal running condition rotar core is
connected to rotar winding through a resistance bridge, as
soon as 1st stage rotar earth fault occur it gives alarm.
Then for 2nd stage rotar core is connected to ground
through a bridge and when 2nd stage rotar earth fault occur
it gives trip command to generator.
(Rotar connection to ground/winding is through a slip-ring
and brush system connected at one end of rotar.)
Santosh Kawade
9224 69 3116
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
how much GROUND & NEUTRAL VOLT maintain in data center.
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
what is the criteria for selection of conductor used for ehv ac electrical dischrge
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
What are the advantages of autotransformer?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what is the difference between the characteristics of two different phase bushing of any transformer
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
What is thresh hold value of current?
What is turn ratio of a transformer?
What do you mean by a voltage transformer?
