Do you know the overhauling of a motor?
Answer Posted / amit banerjee
motor overhauling means first of all inspecting the motor
for any vibration,abnormal sound,high ampere taking and
then opening its parts checking the winding with megger,the
vernishing done if required,changing of bearing if any
vibration or abnormal sound is coming.refitting all
parts,painting and checking ampere after a test run then
installing it again properly.
Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
What is Load sharing of Transformer ?
What is a dominant pole?
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
Igfet is a
wish of these transformer uses oil?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
can any one know is sbi interview based on merit or based on roll number
What is the necessary condition for stability.
Which device is used for the source of emission of electrons in a crt?
Why is better to have a minimum ceiling voltage of 250% than 160%?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.