Interested to Buy Any Domain ? << Click Here >> for more details...
about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ?
- 2 Answers
- 6932 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / alex
Transformer Dielectric oil is tested in a Test Cell, I have
a few of them at home that I inherited from the origional
designer of the test. They look like a thermos flask and you
fill them with a bit of the oil from the transformer and
insert a center section that sits 2mm away from the surface
of the inside of the flask all around (2mm dielectric gap
all round). It is held there with glass / Mica supports. 2KV
is then passed between the inner and outer surfaces (via the
oil) to test its dielectric strength. A high voltage bridge
is normally used to get accurate resistance readings. If
dielectric strenth is low due to contamination it is replaced.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
what is the Connected Load (kW) or Contract Demand (kVA)of mahindra nasik plant??
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
differnce between single acting and double acting solenoid valves
Why is negative feedback invariably preferred in closed loop system?
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
what is Fault level? why it is calculated? how will u decide same for our plant?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
how to calculate transformer turn primary & secondary side 11kv to 420v
what will happen if synchronous machine rotor fed from single phase ac supply
