Answer Posted / srilu
KW is an average power(I*IR)units are KILLO WATTS. where as
KVA is an apperant power (I*I*Z)units are KILO VOLT AMPERES
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
sir i want previous entrance exam papers for written test
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
what is the id1 & id2 setting in differential protection relay of CSPC?
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
WHAT IS MEANT BY DERATING OF THYRISTOR?
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
how was your last weekend.
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
Which do you think is the most significant cause of energy loss in a factory?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES