Interested to Buy Any Domain ? << Click Here >> for more details...
What is the formula to calculate capacitor bank rating for
a certain load.
- 2 Answers
- 9046 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhakar
In India (TNEB),thumb rule is for every 3 HP of inductive
load 1KVAR capacitor to be included in the circuit to
maintain Unity power factor
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how to design the heater in temperature control unit to heat 50KL of water?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
what clearance required for 4.5 mva dry type transformer?
Why can't we parallel the secondary circuits of two voltage transformers?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
How the frame size of a flange mounted AC induction motor is calculated?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
Formulae for calculating the transmission line losses for different voltage levels
why the rotor current becomes in steady state during high slip region? please verify with equations.
Why 3 phase induction motor getting supply in body if one of it's phase is cut
