can we connect both delta and star to the transformer
secondary and for what reason?
- 5 Answers
- 7713 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / pruthi
yes we can but delta connection is mainly used to reduce the
harmonics which defines the quality of signal..
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
When and where resistance earthing is used ? How to calculate the time constant for earth fault
What is trip and closing coil in cb? Why need of them
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
what is the difference between transformer,converter and transducer
What is open delta Xformer? It's adavntages & Use?
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
what is the ATS .And how it works.
what is the difference betweem star connected motor & delta connected motor?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what is the difference between fault current ant short circuit current?
how we can calculate power factor in single phase & three phase ?thank u
why current is constant on d.c?
how is the magnetic current test is different in delta-star and delta delta transformer.
does a DG set has low fault level as compared to that of a transformer.If yes then why.
