Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean by PID controller? And what is its Long form?
- 9 Answers
- 30332 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / bhavini
pid means proportional integral derivative its use for
control system for for o/p feedbak should be minimize and
looping the i/p and o/p by using PID controller
| Is This Answer Correct ? | 25 Yes | 2 No |
Post New Answer View All Answers
Refernce currents are to be generated using refernce cueernts how can this be done
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
Why earthing is necessary for any equipment?
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
how to determine Sq.mm size of finolex power cables.
which book to refer in electrical engineering for iocl exam & which book for general english.
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
What are the basic elements used for modeling mechanical translational system?
Operation of isolators.
what happened when we supply a dc current in dc motor?? can it worked properly?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What are the types of feedback oscillators?
