Answer Posted / arun babu.s
OLTC,can be installed even at secondary side,but the
problem is, the transformer tank should be bigger size,oil
in the transformer needs to designed accordingly to extend
its di-electric property and the tap contacts to be heavy
comparatively,to withstand the high current in the LT side.
Hence,to avoid so,the OLTC designed at PRIMARY side of the
transformer.
| Is This Answer Correct ? | 0 Yes | 10 No |
Post New Answer View All Answers
what is the difference between general inverter and solor inverter clerly explain plz
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
How to calulate Locked rotor amper(LRA) for compressor type motors?
errection check list for transformer maintenance
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
can you plz send l&t aptitude questions if available its urgent plz plz plz
what about the power of wattmeter at starting and loding?
A d.c. Shunt motor is found suitable to drive fans because they require?
what is a synchronizing lamp ?
What is difference between mcb and mccb.
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What test must you do before powering up a circuit that you have been working on?
what is ramping rate of generator
why surge protectetor work explain with the help of circut diagram?
