Interested to Buy Any Domain ? << Click Here >> for more details...
tell 2 reasons for why only copper is used in domestic
wires& only alluminium in transmission lines ?
- 10 Answers
- 17698 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / madhusudhana reddy
1. Copper is costlier than Aluminium(approximately 4
times). As transmission lines span longer distances,
Aluminium is used to keep the initial cost to a low value.
2. Aluminium has higher resistivity/weight ratio.
3. Losses have to be kept to very low value in domestic
purpose. Copper being better conductor than Aluminium is
used for domestic purposes where initial cost involved is
less.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
how to calculate current and voltage in a same circuit?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
Define open loop control system.
why we used ZNO in Lightning arrester.
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
what is difference between earthingpits,earthing grid & earthing mess?
How to check the LM324 Ic
what is POTT and PUTT explain?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
Explain the working principle of Synchronous Generator and Assynchronous generator?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What is FM200 Gas??Applications........
