Interested to Buy Any Domain ? << Click Here >> for more details...
in a transmission line the aluminium cor is sarrounded and
in between there is a another type of matrial what is that?
- 7 Answers
- 8077 Views
- I also Faced
- E-Mail Answers
Answer Posted / muthu
as i already said, steel is used in between al conductor.
because of the gravity and less strength of al the wire
tends to sag. to avoid as well as minimize thw sag steel is
reinforced with in the conductor. that's it.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Starting Time of LT & HT Motor
why ten delta testing is carried out on power transformer
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
if i am in front of transmission line how to know that current direction without any equipment
state the working of discharge lamp?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Can anyone explain me about the capacitor calculation
What do you understand by external characteristics of a d.c. Generator?
