Answer Posted / mkrao
indian standard using for genearal fabrication. Earlier it
was called IS 226 Mild steel
Is This Answer Correct ? | 92 Yes | 34 No |
Post New Answer View All Answers
Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006
Why rate of condensation is higher on a polished surface compared to rusty surface ?
What will happened if two gear boxes in parallel are working with different motor speeds?
what is the difference between set up of cast iron manufacturing industry and steel manufacturing industry?
What is the difference between "stress and strain”?
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
How do you control cylinder liner wear?
Explain what are the thermal conductivity properties of brass?
What are the important operational performance parameters in design of fuel firing equipment ?
At 50 Centigrade (Diesel oil) what is its cast?
about basic questions ofpiping engg
Explain why will an ice cube placed in a cup of hot rotating water spin automatically faster than the water itself?
Explain enthalpy.
Where does Parallel flow heat exchanger use?
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER