Interested to Buy Any Domain ? << Click Here >> for more details...
In a parallel circuit dc circuit with two resistors, if you
know the voltage, amperage, and one resistors ohms, what
formula is used to find the second resistors ohms?
- 6 Answers
- 8350 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
In radial network the source is fed from 1 end both ends at central
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
What happened when voltage will half value of current ...
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
what do u understand about FACTS? how they are useful?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
Why power factor should not be in leading (capacitive) mode of any load.
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
How to minimize the eddy current losses?
what is the difference between Power and Distribution transformers ?
